Name
Phone
Time to call
Captcha*
Call Me Back
Products
Supports for power lines Metal products for substations Water seal Cell tower Other metal

Steel structures for civil engineering

Steel structures for civil engineering

Our factory carries out production of metal structures for civil purposes the following items for the individual and standard designs.

more
Metal structures for reinforced concrete pillars of 10-500 kV

Metal structures for reinforced concrete pillars of 10-500 kV

These metal structures are designed to fix insulating suspension, electrical equipment and other parts support.

more
Antenna support

Antenna support

The antenna support is a freestanding spatial rod designed in the form of a regular pyramid, the top of which is prismatic. There are 3-sided and 4-sided towers. Typical antenna support is designed in six sizes - 30, 40, 50, 60, 70 and 80 meters using sections each 10 meters high. At the same time support of 40 and 50 meters height are formed by the addition of 10-foot sections to support t of 30 meters height, and supports of 70 and 80 meters – by adding sections to support of 60 meters height.

more
Manufactures Hydraulic

Manufactures Hydraulic

«Zhersu Metal» JSC manufactures hydraulic locks of cell type used in pumping stations and treatment plants. Hydraulic locks serve to regulate the inflow of wastewater in the channels at great depths, and wherever frame seal water is below the floor level (deep wells, chambers, etc.).

more
Steel portals for 35-500kV outdoor switchgear

Steel portals for 35-500kV outdoor switchgear

Unified steel structures for outdoor switchgear (OSG) of voltage 35-330 kV are designed for the suspension of bus-bar and installed in open areas of high-voltage stations.  

more
110-330 kV transitional steel supports

110-330 kV transitional steel supports

Transitional supports are installed at the interface device anchoring sites overhead lines and aerial gunner and perceived stress, similar to the intermediate supports, but from two overhead lines. Transitional supports are also affected by efforts from changing the direction of the wires during retraction and anchoring them to the arrow on the curve.

more
35-1150kV intermediate steel supports

35-1150kV intermediate steel supports

Intermediate direct support are installed in straight lines. At intermediate supports with hanging insulators, there wires are fixed in the supporting garlands hanging vertically, on supports with pin insulators binding - wire with a wire stitch. In both cases, the intermediate supports carrying horizontal loads from the wind pressure on the wire and on the vertical support and - the weight of conductors, insulators and its own weight.

more
35-1150kV anchor-angular steel supports

35-1150kV anchor-angular steel supports

Angular supports are set at angles of rotation of line with the suspension wires in supporting garlands. In addition to the loads acting on the intermediate direct support, intermediate and anchor-tension towers perceive as the stress of the transverse components of tension wires and cables. When the angles of rotation of line power are more than 20 ° of angular towers of intermediate weight increases significantly. At large angles of rotation anchor-tension towers are set.

more
Новости 1 - 8 of 9
First | Prev. | 1 2 | Next | Last